Hello,
with ran into a problem with detecting the idle state with Prusa Mini. It seams there are little peaks in VA that exceed the idle limit (set to 15 VA), but these values are not displayed, only the small dot shortly appears on the display. Most of the displayed values in the idle state are between 4 - 9 VA. During the busy state (when printer is printing) are between 8 - 120 VA.
Would it be possible to somehow smooth/filter the values, so the idle state can be detectable? At this moment I’m not able to think of other method to distinguish between the idle/busy state.
Thanks for the reply.
