Ahoy,
I have the following issue.
I recently integrated the FabMan bridge into the safety circuit of our new BRM laser cutter.
I used Relay 2 of the bridge with NO and C and with Auxiliary relay set to mirror primary relay.
And the bridge is on a different electrical circuit than the laser cutters.
But when the bridges are unblocked, it randomly restarts.
I could not narrow it down into any specific action.
No specific time delay either.
It also happens when the laser is idle.
And it does not seems to be specific to a bridge as I have the same issue on my second BRM laser cutter (we got 2 new one at the same time).
I did not try with a different bridge yet.
It is the first time that I integrate the bridges into the safety circuit.